[""] 滴灌灌水器进口通常指滴灌系统中滴灌器进水口。在滴灌灌水器设计中进口位置和设计对于确保水流稳定和灌溉效果至关重要。例如良好设计进口可以有效防止堵塞确保水流均匀分配。在滴灌系统中优质进口设计能够提高系统稳定性和效率从实现高效农田灌溉。
滴灌灌水器进口,inlet of drip irrigation emitter
1)inlet of drip irrigation emitter滴灌灌水器进口
2)drip emitter滴灌灌水器
1.Five different turbulence models provided by current fluid simulation software FLUENT,such as standard k-ε mode1,RNG k-ε model, Realizable k-ε model,standard k-ω model and SST k-ω model,have been used to simulate the flow field ofdrip emitters in this paper.采用通用流体模拟软件FLUENT所提供的5种不同的湍流模型:标准k-ε模型、RNG k-ε模型、Real-izable k-ε模型、标准k-ω模型、SST k-ω模型,对滴灌灌水器微流道内流场水流流动进行了数值模拟。
英文短句/例句
1.Effect of Different Textural Soils on Hydraulic Characteristics of Emitters under Subsurface Drip Irrigation土壤质地对地下滴灌灌水器水力要素的影响
2.Numerical Simulation and Frame Designing of Emitter s Labyrinth Channel;滴灌灌水器迷宫流道结构数值模拟与优化设计
3.Influence of Soil Physical Properties on Emitter Discharge of Subsurface Drip Irrigation土壤物理特性对地下滴灌灌水器流量影响分析
4.Experimental Study on Triangular Labyrinth Channel Design of Drip Irrigation Emitter for Anti-clogging;滴灌灌水器三角形迷宫流道结构抗堵塞性能试验研究
5.Performance of low-discharge emitters buried in soil as affected by layered-textural soils土壤层状质地对小流量地下滴灌灌水器特性的影响
6.Numerical simulation and flow analysis of labyrinth path of drip irrigation emitters滴灌灌水器迷宫流道的内部流体数值模拟与流动分析
7.Analysis on influence factors of subsurface drip irrigation emitter discharge under silt loam soil condition粉壤土条件下影响地下滴灌灌水器流量的因素分析
8.Research on the Relationship between Emitter Working Heads and Uniformity in Low Pressure Drip Irrigation under Different Flow Regime Conditions不同流态条件下低压滴灌灌水器工作水头与灌水均匀度关系的研究
9.More than50% of cane land is irrigated, mainly by sprays or flooding of furrows. Use of low-pressure overhead irrigators and drip systems is increasing.采用喷雾灌溉或渠灌的甘蔗地超过50%，使用低压高架灌溉器和滴水灌溉系统的正在增加。
10.Research of Soybean Water Requirement and Schedule with Drip Irrigation;滴灌大豆需水规律及灌溉制度的研究
11.Experimental Research on Cotton Irrigation Schetual of Under-Film Drip Rotatting Irrigation with Saline Water and Fresh Water;棉花膜下滴灌咸淡水轮灌灌溉制度试验研究
12.Influence of Designed Water Application Ratio on Drip Irrigation System Cost滴灌系统设计供水比对滴灌费用的影响
13.agricultural aspect, should promote using method that saves water, such as spray pumping and drip pumping.农业方面﹐应该推广使用节水技术﹐如喷灌﹐滴灌。
14.Optimization Scheme of Low Pressure Trickle System and Study on Irrigation Uniformity;滴灌系统优化设计与灌水均匀度的研究
15.Study on the Schedule and Water-Fertilizer Coupling Techniques of the Cotton under Mulched Drip Irrigation;棉花膜下滴灌灌溉制度及水肥耦合技术研究
16.Study of Water and Fertilizer Coupling Effect under Drip Fertitigation in Greenhouse Vegetable;温室蔬菜滴灌灌溉施肥水肥耦合效应的研究
17.Experimental Research on Water Consumption and Irrigation System of the Cotton under High-frequency Drip Irrigation Mulched with Plastic Films;膜下高频滴灌棉花耗水量与灌溉制度研究
18.Water Saving Irrigation Pattern Study of Drip Irrigation for Tomato under Mulch in Solar Greenhouse;日光温室膜下滴灌番茄节水灌溉模式试验研究
相关短句/例句
drip emitter滴灌灌水器
1.Five different turbulence models provided by current fluid simulation software FLUENT,such as standard k-ε mode1,RNG k-ε model, Realizable k-ε model,standard k-ω model and SST k-ω model,have been used to simulate the flow field ofdrip emitters in this paper.采用通用流体模拟软件FLUENT所提供的5种不同的湍流模型:标准k-ε模型、RNG k-ε模型、Real-izable k-ε模型、标准k-ω模型、SST k-ω模型,对滴灌灌水器微流道内流场水流流动进行了数值模拟。
3)Drip emitters滴灌灌水器
1.By means of experiment research,water quality standard for drip emitters of Xinjiang Tianye Group Co.通过实验研究 ,得出了新疆天业 (集团 )公司滴灌灌水器要求的水质标准 ,建立了计算玛纳斯河灌区渠水所含粘粒、粉粒、沙粒的去除率经验公式 ,并根据六宫支渠和西岸大渠水质算出了沉淀池设计表面负荷
4)Drip irrigation emitter滴灌灌水器
1.Numerical simulation and flow analysis of labyrinth path of drip irrigation emitters滴灌灌水器迷宫流道的内部流体数值模拟与流动分析
5)drip irrigation with saline water咸水滴灌
1.Salt crust is a unique layer that forms on the soil surface underdrip irrigation with saline water in the shelterbelts along the Trim Desert Highway.盐结皮是咸水滴灌条件下塔里木沙漠公路防护林土壤表层形成的一种特殊层结。
6)water conservation and dripping irrigation储水滴灌
1.The results showwater conservation and dripping irrigationprovides a steady and sustainingwater serving system for orchard on droughty hilly country.研究结果表明:储水滴灌为干旱山地果树生长提供了一个比较稳定而持久的水分供应系统。
延伸阅读
电力电容器灌封料分子式：CAS号：性质：树脂(A)为聚醚填充料等，固化剂(B)为改性异氰酸酯等。由聚醚与辅助材料经脱水精制后再加填充料和催化剂进行反应，然后经研磨混合、过滤而成。树脂为白色或黄色黏液。密度1.35～1.40g/cm3。黏度(25℃)7000mPa·s左右。固化剂为黑色或黄色黏液。密度1.10～1.15g/cm3，黏度(25℃)5500mPa·s左右。用于电容器元件特别适用于电力电容器的表面密封和固定。
